INSTRUCTIONS TO ENABLE SATAIDE MODE FOR H8DSR8 UNDER REDHAT

INSTRUCTIONS CONSIDER EACH ITEM SEPARATELY AND RATE EACH ITEM
STAT 103 HOMEWORK THREE SOLUTIONS SPRING 2014 INSTRUCTIONS THE
COVERAGE PERIOD [SEE INSTRUCTIONS] S UMMARY OF

FINAL INSTRUCTIONS NO 1 THANK YOU FOR
CONTACT US LADDER GOLF OFFICIAL RULES AND INSTRUCTIONS
SOIL AND WATER CONSERVATION DISTRICT INSTRUCTIONS FOR ENDOFYEAR

Instructions to Enable SATA-IDE Mode for DSP-8 under RedHat Linux

Instructions to Enable SATA-IDE Mode for H8DSR-8 under RedHat Linux Operating Systems


  1. In the command prompt, type the following at the command line and then install OS:

linux ide1=0xac00,0xa880 (if only one SATA drive attached)

linux ide1=0xac00,0xa880 ide2=0xa800,0xa480 (if two SATA drives attached)

  1. During the GUI installation, in the “GRUB boot loader Configuration” section, check the “Configure advanced boot loader option” box, and press enter to the ext step.

  2. In the “GRUB boot loader Configuration” page, type the following in the “General Kernel Parameters” field, then press next:

ide1=0xac00,0xa880 (if only one SATA drive attached)

ide1=0xac00,0xa880 ide2=0xa800,0xa480 (if two SATA drives attached)

  1. Continue and finish the installation.


Note:



VEHICLE DVR PRODUCT INSTRUCTIONS 48 ROAD 1080P HD
(2 PHOTOS) PERSONAL HISTORY FORM SEP INSTRUCTIONS PLEASE
(A)LINDA LINGLE GOVERNOR INSTRUCTIONS FOR GENERAL APPLICATION CATEGORY I


Tags: enable sata-ide, under, h8dsr8, enable, redhat, sataide, instructions