INFORMACIONE TEHNOLOGIJE IT13 NASLOV RADA (PAPER TITLE ON MONTENEGRIN

Informacione tehnologije IT'13

1. PAPER SUBMISSION

Completed paper is sent by e-mail in MS Word format (Times New Roman font) at email address: [email protected] or via "Paper submission" form on the web site http://www.it.ac.me/.

2. PAPER PREPARATION GUIDELINES

Paper text should be prepared according to these Guidelines!

Papers can be written in English, Montenegrin, Serbian, Croatian or Bosnian language.

Paper is limited to 4 pages, written in A4 format, Times New Roman font.

Margins of manuscript pages should be as follows: upper, lower and left margin 2 cm each and right margin 1 cm.

Paper title is written in the middle of the first page, two blank lines from the upper margin, bold letters font size 12 points.

Names of the authors and their institutions are written beneath the paper title in English, font size 10 points. After the authors’ names, names of institutions whereat authors are employed are written in italic, font size 10 points, as given in the Guidelines.

Content and abstract are written with a single blank line from the name of the author, within space 2 cm distant from the left and right margin, in italic letter, font size 10 points, in a way given by the above example.

Paper is written with two blank lines after the content and abstract, in two columns, at distance of 5 mm: Paper should be typed with spacing 1 and 10 points font size, in a way these Guidelines were typed too.

New line has a first line indent of 5 mm and single line break from the previous paragraph.

Subtitles are written in bold CAPITAL LETTERS with serial number of the subtitle and font size 10 points.

Illustrations (tables, figures, diagrams) can be even wider than one column. Number and title are indicated above the table, i.e. below the figure (Table 2. ...; Figure 3. ...) in the same font as the paper text itself.

In the case when the last page is not filled up, columns on that page should be adjusted to same height, as it was done in these Guidelines.

REFERENCES

References in the paper are quoted in square brackets by the order of reference. For example, in [2] it was indicated... You can see examples of quoted references at the end.

1. V. I. Utkin, "Variable structure control systems with sliding modes, "IEEE Trans. Automat. Control, AC-22, pp. 210-222, April 1977.

2. A. E. Bryson and Y. C. Ho, Applied Optimal Control, New York: Wiley, 1975.

3. B. K. Bose, Sliding mode control of induction motor, In. Proc. IEEE Ind. Appl. Soc. Annu. Meeting, pp 479-486, 1985.